![]() ![]() You'll be cutting the glass yourself, and in a slight curved pattern, so note the following: Now that you have the wood tabletop cut and square, it's time to cut your glass inset. Just be careful of tear-out.Ĭongratulations! You have the beginnings of a table! Changing blades to a crosscut blade would be preferable, but you can get away with using the rip cut blade. Then, square off the short edges with the circular saw again, using a straightedge and guide will help. Arrange them so that the freshly cut edges are parallel to one another. Once you have cut the wood slab down its length, swap the two pieces so that the live edge is facing inward. The circular saw will do a reasonable job itself of cutting a straight line, but having a clamped straight edge to run the tool against will help. Tip: Find a flat edge and clamp it to your wood so that you can run the circular saw against the edge and ensure that you get a straight line. Be sure to support the wood well enough so that each half will still be stable even after the piece is cut in two. Lay the wood down on a set of 2"x4"s or some other elevated material so you can cut through without the saw blade hitting the ground. This prevents the wood from overheating and burning as the blade cuts. The thinner profile helps maintain a smoother cut, and because it isn't as wide, you aren't removing as much wood. Look for a thin-kerf blade in particular. Rip cut blades are designed to move quickly through wood with the grain, removing material and maintaining a relatively smooth profile. ![]() Rip cut blades have fewer teeth (typically 24-40 tooth count), and a distinctive shape to the blade profile.Use a circular saw with a good rip cut blade instead. As there is not a straight edge to guide the cut on a table saw, and the wood is large and heavy, you can easily get the saw blade stuck, and the table saw would then throw the wood straight back into your body.which wouldn't be awesome for you. This meant we had to cut the wood at an angle lengthwise down the piece. We wanted the live edge to run at an angle in the table, and to preserve the interesting wood patterns at each end. The most important thing in this step is to make sure you know what you want your table to look like, and to take care when cutting the wood itself. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |